No power to the Opener. Before installing your garage door opener, open and close your door manually to ensure that it operates smoothly from top to bottom. Pliers If required by local codes, the Opener can 2 Screws. Close S-Hook Threading Disconnect Cable Guide Bracket Thread the Disconnect Cable Guide Tools Needed:. You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www. This light fixture has a grounding type plug with a third grounding pin.
Identify which side of the garage door is exposed to the most sunlight. Phillips Head Screw Installing Battery Wall Station Remove the Battery Cover right-hand side. Press the Red Program Button on the Tools Needed: light fixture. Installing Opener Place the Opener over the Torsion Tube Tools Needed: and between the two Gear Assemblies. Note: The idrive will remain in the learn mode for ®. When assembling Diffuser, make sure all three Snap Tabs are aligned and fully snapped into the three Mating Slots of the Light Fixture. Opener works from the Wall Station but not from the Transmitter is not programmed.
Screwdriver Once wall station is snuggly onto lower screw, install upper screw. . The idrive ® unit will beep once, indicating that it is ready to learn. To change the automatic pet opening height refer to the following procedure: a. This blink rate can be changed out-of-balance condition causes the door to stop while opening or for longer battery life or can be turned off. Align top of the Bracket Tape measure with the mark. Apply grease along the Torsion Tube where the Opener will mount.
The Manufacturer warrants that the idrive Garage Door Opener will be free from defects in materials and workmanship including electronic components for a period of ®. Press the red program button on the idrive ® Opener. If the Motor does not pivot down, or only Tools Needed: pivots down partially, the Detent Pin is set too hard. . Tools Needed: If they are worn, frayed or broken, contact None a qualified door service company to replace the cables before installing the cable keepers. Check the Opener power cord to outlet connection.
. The Safety Sensors should be mounted as close to the door Wall Mounting Bracket track or inside edge of the door as. If you were referred to these instructions as part of a new door installation, then proceed with these instructions beginning with Step 1 on page 7. Teaching HomeLink to the idrive Motorhead Unit ® ® 6. See Steps 28 Wall Station Step 38 Transmitter. D o not connect the Opener to electrical power until Maintenance. Wayne Dalton Quantum Garage Door Opener Learn On Model Openers Wayne dalton idrive pro 3790 z user manual 52 pages also for wayne dalton garage door opener remote zoemichela wayne dalton garage door opener troubleshooting wayne dalton idrive garage door opener luxury wst 372aswv garage wonderful wayne dalton door opener ideas.
Pay close attention to all warnings and notes. Wire cutters Using a pair of Needle Nose Pliers, gently Flat Tip pull terminal block from right hand side of Screwdriver opener. If an locate the wall station in a dark garage. If the header does not provide a Tools Needed: Tools Needed: mounting surface for the Opener, a None proper mounting surface will need to be installed. All others Must use Photo Eyes. Mounts on tHe wall Instead oF clutterInG tHe ceIlInG. .
. . . . . . .
. . . . . .
. . . . .